XL-7 Limited 4WD V6-2.7L (2002)
![background image](/suzuki/xl-7_limited_4wd/v6-2.7l/Page-1448001.png)
Trunk / Liftgate Lock: Service and Repair
Back Door/Rear Gate Lock Assembly
Removal
1. Remove inside handle bezel (1) (if equipped).
2. Remove inside lock knob.
3. Remove door trim (1).
With inside handle bezel tilted as shown in figure, turn door trim 90 degree counterclockwise to remove it.
4. Remove back door/rear gate sealing cover.
5. Remove back door rear/gate lock control rod (1).
Unlock back door/rear gate lock rod pin retainer and disconnect control rod.
6. Disconnect back door lock motor lead wire.
7. Remove lock assembly.
Installation
Reverse removal procedure to install back door lock assembly noting the following points.