XL-7 Limited 4WD V6-2.7L (2002)
5. Remove strut bracket bolts (3) from strut bracket.
6. By using puller (1), disconnect knuckle (2) from ball stud (3).
7. While lowering jack, remove knuckle/wheel spindle assembly.
8. Remove inner oil seal (4) (for 4WD vehicle), knuckle cap (4) (for 2WD vehicle), dust cover (1) and wheel spindle (2) from knuckle (3).
9. For 4WD vehicle, Remove drive shaft bearing (2) from wheel spindle (1) by using special tools.
Special tool
(A): 90023-74510
(B): 09930-30102
Installation
Reverse removal sequence to install knuckle, wheel spindle oil seal and drive shaft bearing, noting the following points.