XL-7 Plus 2WD V6-2.7L (2001)
1. Before installing valve lash adjuster to cylinder head, fill oil passage of cylinder head with engine oil according to the following procedure.
Pour engine oil through oil holes and check that oil comes out from oil holes in sliding part of valve lash adjuster. Perform this check on both
intake and exhaust sides.
2. Valve lash adjuster to cylinder head. Apply engine oil around valve lash adjuster and then install it to cylinder head.
3. Check timing mark on crankshaft as shown in the figure.
4. Install RH bank camshafts.
5. Install LH bank camshafts.
Apply oil to sliding surface of each camshaft and camshaft journal then install them by aligning match marks on cylinder head and LH bank
camshafts as shown in the figure.
