XL-7 Plus 2WD V6-2.7L (2001)
Seals and Gaskets: Service and Repair
REMOVAL AND INSTALLATION
1. Lift vehicle horizontally.
2. Remove rear propeller shaft from extension case.
3. Pry shroud, felt and oil seal with flat-bladed tool.
4. Be sure to apply grease to oil seal (1) lip. Using special tool and plastic hammer, press-fit new oil seal (1), felt (2) and shroud (3) up to position
indicated in figure.
"A": Grease 99000-25010
Special tool (A): 09940-53111
5. Install rear propeller shaft.