XL-7 Standard 2WD V6-2.7L (2001)
Wheel Speed Sensor: Service and Repair
Rear Wheel Speed Sensor
REAR SENSOR ROTOR (RETAINER RING)
REMOVAL
1. Remove rear axle shaft assembly.
2. In order to remove sensor rotor (retainer ring) (2) from shaft (1), grind with a grinder one part "A" of the sensor rotor (retainer ring) as shown till it
becomes thin.
CAUTION:
^
Cover vinyl sheet (3) or the like over wheel bearing so that fine grains from grinding will not enter there.
^
Be careful not to go so far as to grind the retainer ring.
3. Break with a chisel (1) the thin ground sensor rotor (retainer ring) (2), and it can be removed.
INSTALLATION
1. Press-fit sensor rotor (retainer ring) (1) as shown in the figure.
2. Install rear axle shaft assembly.