XL-7 Standard 2WD V6-2.7L (2001)
-
SDM
-
Check for external damage such as deformation, scratch, crack, peeled paint, etc.
-
Check that SDM cannot be installed properly due to a cause in itself. (There is a gap between SDM and SDM plate, or it cannot be fixed
securely.)
-
Check that connector or lead wire of SDM has a scorching, melting or damage.
-
Check SDM connector and terminals for tightness.
-
Check SDM sets a diagnostic trouble code (Refer to "DTC CHECK".) and the diagnostic table leads to a malfunctioning SDM. See: Air Bag
Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/How to Display and Read Diagnostic Trouble Codes
If any faulty condition is found in above checks, replace.
-
Air bag wire harness and connections
-
Check for damages, deformities or poor connections.
-
Check wire harness clamps for tightness.
If any faulty condition is found, correct or replace.
-
Forward sensor
-
Check sensor (1), sensor bracket (2), and front panel (3) for damage bend or rust.
-
Check that connector (4) or lead wire (5) of forward sensor has a scorching, melting or damage.
If any faulty condition is found in above checks, replace.
