XL-7 Touring 2WD V6-2.7L (2001)
Camshaft Position Sensor: Service and Repair
CAUTION: Disassembly Is prohibited. If anything faulty is found, replace as an assembly unit.
REMOVAL
1. Disconnect CMP sensor coupler (2).
2. Remove A/T fluid level gauge and filler tube.
3. Remove CMP sensor (1) by removing bolt (3).
INSTALLATION
NOTE: After Installing CMP sensor, adjust ignition timing. (Refer to "IGNITION TIMING CHECK AND ADJUSTMENT").
1. Install a new O-ring (2) with engine oil applied to CMP sensor (1).