XL-7 Touring 4WD V6-2.7L (2002)
-
Do not pull wire harness or twist more than necessary when installing front wheel speed sensor.
-
Fit harness grommet to inner fender securely.
Tightening torque
Front wheel speed sensor harness clamp bolt (a): 10 Nm (1.0 kgf-m, 7.5 ft. lbs.)
Front wheel speed sensor bolt (b): 23 Nm (2.3 kgf-m, 17.0 ft. lbs.)
3. Check that there is no clearance between sensor (1) and knuckle.
Inspection
Check sensor for damage.
Check sensor for resistance.
Resistance between terminals (Front wheel speed sensor) 1.2 - 1.6 k Ohms (at 20°C (68°F))
Resistance between terminal and sensor body (Front wheel speed sensor) 1 M Ohms or more
If any faulty is found, replace.
Rear
Removal
1. Disconnect negative cable from battery.
2. Hoist vehicle.
3. Disconnect rear wheel speed sensor connector (2) and detach wire harness (1) from vehicle body and rear axle.
4. Remove harness clamps (2) and sensor bolt (1)