XL-7 Touring 4WD V6-2.7L (2002)
Air Bag Control Module: Service and Repair
WARNING: During service procedures, be very careful when handling a Sensing and Diagnostic Module (SDM). Be sure to read "Precautions
on Service and Diagnosis of Air Bag System" before starting to work and observe every precaution during work. Neglecting them may result in
personal injury or inactivation of the air bag system when necessary.
Removal
1. Disconnect negative (-) cable at battery.
2. Disable air bag system referring to "Disabling Air Bag System".
3. Remove rear and front center console box (1) by removing screw and clips.
4. Remove center garnish panel (2).
5. Remove ashtray (3) and tuner assembly, clock assembly (5), tuner pocket, radio hole cover (4), etc.
6. Disconnect SDM connector (1) from SDM (2).
7. Remove SDM (2) from vehicle.
Installation
1. Check that none of the following faulty conditions exists.
-
Bend, scratch, deformity in vehicle body mounted on SDM
-
Foreign matter or rust on mating surface of vehicle body mounted on SDM
2. Install SDM (2) to vehicle.
CAUTION: Ensure that arrow on the SDM is pointing toward the front of the vehicle.
3. Tighten SDM bolts to specified torque.
Tightening torque
SDM bolt (a): 6 N.m (0.6 kg-m, 4.5 lb-ft)
