XL-7 Touring 4WD V6-2.7L (2002)
Clockspring Assembly / Spiral Cable: Service and Repair
Contact Coil and Combination Switch Assembly Removal and Installation
CAUTION: Do not turn contact coil (on combination switch) more than allowable number of turns (about two and a half turns from the center
position clockwise or counterclockwise respectively), or coil will break.
Removal
1. Remove steering wheel from steering column.
2. Remove steering column hole cover (1).
3. Remove steering column cover screws (1) (3 pieces).
4. Separate upper cover (2) and lower cover (3), then remove them.
5. Disconnect all connectors for contact coil and combination switch assembly.
6. Remove contact coil and combination switch assembly (1) from steering column.
Installation
1. Check to make sure that vehicle's front tires are set at straight-ahead position and then ignition switch is at "LOCK" position.