XL-7 Touring 4WD V6-2.7L (2002)
12. Remove stud bolt(s) (1) by using hydraulic press (2).
Installation
1. Aligning serrations between new stud bolt(s) (1) and flange (4), install new stud bolt(s) (1) by tightening nut (2) as shown in the figure.
2. Install bearing retainer (5) to axle shaft.
A: Type 1 For Koyo Bearing, B: Type 2 For SKF Bearing
3. Press fit new wheel bearing (1) and new retainer ring (2) using press (3).
NOTE:
^
Use care not to cause any damage to outside of retainer ring (2).
^
Seal side (4) of wheel bearing must face bearing retainer (5) side.
4. Install circlip to axle shaft.