XL-7 Touring 4WD V6-2.7L (2002)
Quarter Window Glass: Procedures
Quarter Window Removal and Installation
Refer to "Windshield Removal and Installation" procedures are basically the same. However, note the followings.
-
Before applying primer to glass edge, install molding according to installing position shown in the figure.
-
Observe the following precautions when applying adhesive along glass edge.
-
Adhesive should be applied evenly especially in height.
-
Be careful not to damage primer.
-
Press glass against body quickly after adhesive is applied.
Adhesive amount specification (quarter window)
Height "a": 12 mm (0.47 in.)
Width "b": 8 mm (0.31 in.)
Width "C": 16 mm (0.63 in.) for glass front, rear and upper section.
Width "C": 14 mm (0.55 in.) for glass bottom section.
Position "e": 177 mm (6)97 in.) for left side glass front section.
Position "e": 75 mm (2)95 in.) for right side glass front section.
Position "d": 29 mm (1)15 in.) for glass rear section.
Position "d": 39 mm (1)54 in.) for glass upper section.
Position "d": 22 mm (0.87 in.) for glass bottom section.