Camry L4-1995cc 2.0L SOHC (2S-E) (1984)
Wire Routing
7.
Connect brown wire, then red wire to the (+) ignition coil terminal.
8.
Connect yellow wire, then blue wire to the (-) ignition coil terminal.
9.
Check that wires are routed properly into the grooves as illustrated.
Igniter
10.
Install igniter cover, coil cover, rotor and distributor cap.
11.
Connect green wire connector to the distributor assembly.
CLAMPS
12.
Close the No. 2 engine cover and fold the center floor carpet down.
Note:
Hand tighten the set bolts first starting at the console assembly; then tighten.
13.
Install the two clamps as illustrated, then attach the accelerator cable.