Camry Sedan L4-2.4L (2AZ-FE) (2003)
9.
Reinstall the seat to the floor and hand tighten all 4 mounting bolts to prevent the seat from moving.
NOTICE
Seat motor/gear drive assembly MUST be replaced with the seat bolted to the floor to prevent misalignment of the left and right track guides.
10.
WIth the seat in the full forward position loosen the two 12-mm nuts at the front of the seat track as shown.
NOTE
Do NOT remove the nuts.
11.
Move the seat to the full rear posiuon then remove the two nuts.
12.
Remove the 4 allen bolts securing the motor gearboxes to the seat as shown.
NOTE
There are two bolts on each side.
13.
Disconnect the connector to the motor.
14.
Remove the motor and gear box assembly.
15.
Remove the two washers located behind the gearbox on each side.
16.
Turn both splined shafts fully clockwise (1/4 turn or less) to take up any slack and align the shafts.
NOTE
In some instances, there may not be any slack.