Camry Sedan L4-2.4L (2AZ-FE) (2003)
/Page-1226003.png)
-
Use gloves and safety glasses when handling a front seat airbag assy with the deployed airbag.
-
Do not apply water, etc. to a front seat airbag assy with the deployed airbag.
-
Always wash your hands with water after completing the operation.
HINT: When scrapping a vehicle, deploy the airbag and scrap the vehicle with the front seat airbag assy still installed.
Deployment When Disposing of Side Airbag Assembly
DISPOSAL
HINT: When scrapping vehicles equipped with an SRS or disposing of the front seat airbag assy always first deploy the airbag in accordance with the
procedure described. If any abnormality occurs with the airbag deployment, contact the SERVICE DEPT. of TOYOTA MOTOR SALES, U.S.A., INC.
When disposing of a front seat airbag assy with an airbag deployed in a collision, follow the same procedure given in step 1-(e) in "DISPOSAL".
CAUTION:
-
Never dispose of a front seat airbag assy which has an undeployed airbag.
-
The airbag produces a sizeable exploding sound when it deploys, so perform the operation out of doors and where it will not create a nuisance to
nearby residents.
-
When deploying the airbag, always use the specified SST (SRS Airbag Deployment Tool), perform the operation in a place away from electrical
noise.
-
When deploying an airbag, perform the operation at least 10 m (33 ft) away from the airbag assy.
-
The front seat airbag assy is very hot when the airbag is deployed, so leave it alone for at least 30 minutes after deployment.
-
Use gloves and safety glasses when handling front seat airbag assy with the deployed airbag.
-
Always wash your hands with water after completing the operation.
-
Do not apply water, etc. to a front seat airbag assy with the deployed airbag.
DISPOSE FRONT SEAT AIRBAG ASSY RH (WHEN DISPOSING OF AIRBAG ASSEMBLY DEPLOYMENT METHOD)
NOTE:
-
When disposing of the front seat airbag assy only, never use the customer's vehicle to deploy the air- bag.
-
Be sure to follow the procedure given below when deploying the airbag.
HINT: Have a battery ready as the power source to deploy the airbag.
a. Remove the front seat airbag assy.
1. Remove the 2 nuts and front seat airbag assy from the seatback assembly.
CAUTION: Store the front seat airbag assy with the airbag deployment side facing upward.
b. Using a service-purpose wire harness, tie down the front seat airbag assy.