Camry Sedan 4-Door L4-132 2164cc 2.2L DOHC (5S-FE) (1995)
c. Coat the lip of the oil seal with MP grease.
7. TRANSAXLE CASE SIDE:
IF NECESSARY, REPLACE SIDE OIL SEAL
a. Using a screwdriver and hammer, drive out the oil seal.
b. Using SST and a hammer, drive in a new oil seal until its surface is flush with the case surface.
SST 09350-32014 (09351-32130, 09351-32150)
c. Coat the lip of oil seal with MP grease.
8. TRANSMISSION CASE SIDE:
IF NECESSARY, REPLACE SIDE BEARING OUTER RACE
a. Using a brass bar and hammer, drive out the bearing outer race.
b. Install the bearing retainer without an O-ring.
c. Install and torque the bearing retainer bolts.
Torque: 18 N.m (185 kgf-cm, 13 ft-lbf)
d. Place the thinnest shim into the case.