Camry Wagon L4-2.0L (3S-FE) (1990)
2. INSTALL WATER INLET HOUSING AND THERMOSTAT ASSEMBLY
-
Install the water inlet housing and thermostat assembly with the two nuts.
Torque: 8.8 N-m (78 in-lb, 90 kg-cm)
3. CONNECT RADIATOR LOWER HOSE
4. CONNECT WATER TEMPERATURE SWITCH CONNECTOR
5. FILL WITH ENGINE COOLANT
6. START ENGINE AND CHECK FOR LEAKS
3. INSTALL WATER INLET PIPE
(a) Install a new 0-ring to the water inlet pipe.
(b) Apply soapy water to the 0-ring.
(c) Connect the water inlet pipe to the water inlet.
(d) Install the bolt holding the water inlet pipe to the alternator belt adjusting bar.
Torque: 20 N-m (14 ft-lb, 200 kg-cm)
4. INSTALL TIMING BELT
5. CONNECT RADIATOR LOWER HOSE
6. FILL WITH ENGINE COOLANT