Camry Wagon V6-180.5 2959cc 3.0L DOHC (3VZ-FE) (1993)
18. IF RE-USING TIMING BELT, CHECK INSTALLATION MARKS ON TIMING BELT
Check that there are four installation marks on the timing belt by turning the crankshaft pulley as shown in the illustration.
If the installation marks have disappeared, place a new installation mark on the timing belt before removing each part.
19. SET NO.1 CYLINDER TO TDC/COMPRESSION
a. Turn the crankshaft pulley and align its groove with the timing mark "0" of the No.1 timing belt cover.
b. Check that timing marks of the camshaft timing pulleys and No.3 timing belt cover are aligned.
If not, turn the crankshaft one revolution (360°).
20. REMOVE TIMING BELT TENSIONER
Remove the two bolts, tensioner and dust boot
21. REMOVE TIMING BELT FROM CAMSHAFT TIMING PULLEY
HINT: (Re-using timing belt): If the installation marks have disappeared, before removing the timing belt, place new installation marks on the
timing belt to match the timing marks of the camshaft timing pulleys.