Camry Wagon V6-180.5 2959cc 3.0L DOHC (3VZ-FE) (1993)
Fuel Pressure: Testing and Inspection
Cold Start Valve Line
- Check that the battery voltage is above 12 volts.
- Disconnect the cable from the negative (-) terminal of the battery.
CAUTION:Work must be started after approx. 30 seconds or longer from the time the ignition switch is turned to the LOCK position and the
negative (-) terminal cable is disconnected from the battery.
- Disconnect the cold start injector connector.
- Put a suitable container or shop towel under the cold start injector pipe (No.2 fuel pipe).
- Remove the union bolt and two gaskets, and disconnect the cold start injector pipe from the cold start injector.
HINT: Slowly loosen the union bolt.
Connecting Gauge
- Install pressure gauge to the cold start injector with three new gaskets and the union bolt.
Torque: 15 N.m (150 kgf.cm. 11 ft.lbs)
- Wipe off any splattered gasoline.
Installing Jumper Wire
- Using a jumper wire, connect terminals + B and FP of the check connector.
- Reconnect the battery negative (-) cable.