Camry Wagon V6-180.5 2959cc 3.0L DOHC (3VZ-FE) (1993)
8. ASSEMBLE INBOARD JOINT BOOT TO IN BOARD JOINT
-
Pack in grease to the inboard tulip and boot.
HINT: Use the grease supplied in the boot kit.
Grease capacity:
TOYOTA Type: 90-100 g (3.2-3.5 oz.)
GKN Type: 140-150 g (4.9-5.3 oz.)
9. (TOYOTA TYPE)
ASSEMBLE BOOT CLAMPS TO BOTH BOOTS
-
Be sure the boots are on the shaft groove.
-
Insure that the boots are not stretched or contracted when the drive shaft is at standard length.
Drive shaft standard length:
LH 456.0 mm (17.953 in.)
RH 455.9 mm (17.949 in.)
-
Bend the band and lock it as shown.
(GKN TYPE)
ASSEMBLE BOOT CLAMPS TO BOTH BOOTS
-
Be sure the boots are on the shaft groove.
-
Insure that the boot is no stretched or contracted when the drive shaft is at standard length.
Drive shaft standard length:
452.35 ± 2.0 mm (17.8090 ± 0.079 in.)