Camry XLE Sedan L4-2164cc 2.2L DOHC (5S-FE) MFI (1999)
Oxygen Sensor: Testing and Inspection
Heated Oxygen Sensor -Except California
Bank 1 Sensor 1
1. INSPECT HEATER RESISTANCE OF HEATED OXYGEN SENSOR
a. Disconnect the oxygen sensor connector.
b. Using an ohmmeter, measure the resistance between terminals +B and HT
Resistance: 11 - 16 Ohms at 20° C (68° F)
If the resistance is not as specified, replace the sensor.
Torque: 44 N.m (450 kgf.cm, 32 fl.lbf)
c. Reconnect the oxygen sensor connector.
2. INSPECT OPERATION OF HEATED OXYGEN SENSOR: See "Related Diagnostic Charts" in this section
Bank 1 Sensor 2
1. INSPECT HEATER RESISTANCE OF HEATED OXYGEN SENSOR
a. Disconnect the oxygen sensor connector.
b. Using an ohmmeter, measure the resistance between terminals +B and HT.
Resistance: 11 - 16 Ohms at 20° C (68° F)
If the resistance is not as specified, replace the sensor.
Torque: 44 N.m (450 kgf.cm, 32 ft.lbf)
c. Reconnect the oxygen sensor connector.
2. INSPECT OPERATION OF HEATED OXYGEN SENSOR: See "Related Diagnostic Charts" in this section