Camry XLE Sedan L4-2164cc 2.2L DOHC (5S-FE) MFI (1999)
^
Use a torque wrench with a fulcrum length of 300 mm (11.81 inch).
^
This torque value is effective in case that SST is parallel to a torque wrench.
5. CONNECT CLAMP PLATE
Torque the nut.
Torque: 10 Nm (1100 kgf-cm, 7 ft. lbs.)
6. CONNECT INTERMEDIATE SHAFT ASSEMBLY
7. CONNECT RIGHT-HAND AND LEFT-HAND TIE ROD ENDS
8. POSITION FRONT WHEELS FACING STRAIGHT AHEAD
HINT: Do it with the front of the vehicle jacked up.
9. CENTER SPIRAL CABLE
10. INSTALL STEERING WHEEL
a. Install the wheel at straight-ahead position.
b. Temporarily tighten the wheel set nut.
c. Connect the connector.
11. BLEED POWER STEERING SYSTEM
12. CHECK STEERING WHEEL CENTER POINT
13. TORQUE STEERING WHEEL SET NUT
Torque: 35 Nm (360 kgf-cm, 26 ft. lbs.)
14. INSTALL STEERING WHEEL PAD
15. CHECK FRONT WHEEL ALIGNMENT