Celica L4-1.8L (2ZZ-GE) (2005)
(f) Install the ignition coil.
21. 2ZZ-GE: INSTALL CYLINDER HEAD COVER
(a) Remove any old packing (FIPG) material.
HINT: When FIPG on the head cover gasket side cannot be eliminated completely, replace the gasket.
(b) Apply seal packing to 2 locations as shown in the illustration.
Seal packing:
Part No.08826-00080 or equivalent
(c) Install the gasket to the cylinder head cover.
HINT: Part must be assembled within 3 minutes of application. Otherwise the material must be remove and reapplied.
(d) Install a new O-ring to the cylinder head cover.
(e) Install the cylinder head cover and wire harness protector with the 9 bolts. Uniformly tighten the bolts, in the several passes, in the sequence
shown.
Torque: 10 Nm (100 kgf-cm, 7 ft-lbf)
(f) Connect the 2 PCV hoses to the cylinder head cover.
(g) Install a new gasket and No.1 ventilation pipe with 2 nuts and bolt.
Torque:
Nut: 10 Nm (100 kgf-cm, 7 ft-lbf)
Bolt: 25 Nm (255 kgf-cm, 18 ft-lbf)