Celica L4-1.8L (2ZZ-GE) (2005)
Measuring Point Reference
5. INSPECT TOE-IN
Toe-in
If the toe-in is not within the specified value, adjust it at the rack ends.
6. ADJUST TOE-IN
a. Remove the rack boot set clips.
b. Loosen the tie rod end lock nuts.
c. Turn the right and left rack ends by an equal amount to adjust the toe-in.
HINT: Try to adjust the toe-in to the center of the specified value.
d. Make sure that the lengths of the right and left rack ends are the same.
Rack end length difference: 1.5 mm (0.059 inch) or less
f.
Torque the tie rod end lock nuts.
Torque: 74 Nm (750 kgf-cm, 54 ft. lbs.)
f.
Place the boots on the seats and install the clips.
HINT: Make sure that the boots are not twisted.