Celica L4-1.8L (2ZZ-GE) (2005)
3. INSPECT ROTOR FOR GROUND
Using an ohmmeter, check that there is no continuity between the slip ring and rotor
If there is continuity replace the rotor
4. INSPECT SLIP RINGS
a. Check that the slip rings are not rough or scored.
If rough or scored, replace the rotor.
b. Using a vernier caliper, measure the slip ring diameter.
Standard diameter: 14.2 - 14.4 mm (0.559 - 0.567 in.)
Minimum diameter: 12.8 mm (0.504 in.)
If the diameter is less than minimum, replace the rotor.
5. INSPECT STATOR (DRIVE END FRAME) FOR OPEN CIRCUIT
Using an ohmmeter, check that there is continuity between the coil leads.
If there is no continuity, replace the drive end frame assembly