FJ Cruiser 4WD V6-4.0L (1GR-FE) (2007)
Crankshaft Position Sensor: Service and Repair
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE V-BANK COVER
3. REMOVE FAN
Refer to the procedures up to "REMOVE FAN ".
4. REMOVE GENERATOR ASSEMBLY
Refer to the procedures up to "REMOVE GENERATOR ASSEMBLY"
5. SEPARATE COOLER COMPRESSOR ASSEMBLY
a. Remove the bolt, then separate the suction hose sub-assembly.
b. Disconnect the cooler compressor assembly connector.
c. Remove the 4 bolts, then separate the cooler compressor assembly from the V-ribbed belt tensioner assembly.
6. REMOVE CRANKSHAFT POSITION SENSOR
a. Disconnect the crankshaft position sensor connector.
b. Remove the bolt, then remove the crankshaft position sensor.
INSTALLATION
1. INSTALL CRANKSHAFT POSITION SENSOR