RAV4 4-Door 4WD L4-2.0L (3S-FE) (1997)
Inspection
INSPECTION
Inspect shock absorber.
Compress and extend the shock absorber rod and check that there is no abnormal resistance or unusual operation sounds. If there is any
abnormality, replace the shock absorber with a new one.
Disposal
DISPOSAL
1. Fully extend shock absorber rod.
2. Drill hole to remove gas from cylinder. Using a drill, make a hole near the center of cylinder as shown to remove the gas inside.
CAUTION: The gas coming out is harmless, but be careful of chips which may fly up when drilling.
Shock Absorber Lower Pivot Pin
SHOCK ABSORBER LOWER PIVOT PIN REPLACEMENT
1. Remove shock absorber lower pivot pin.
a. Mount No. 1 suspension arm in a vise.
b. Remove the nut.
c. Using a plastic hammer, remove the pivot pin.
2. Install shock absorber lower pivot pin.
a. Install the pivot pin.
b. Install the nut.
Torque: 140 Nm (103 ft. lbs.)