Tacoma 2WD V6-3.4L (5VZ-FE) (1995)
Coolant Temperature Sensor/Switch (For Computer): Service and Repair
NOTICE: Installation is in the reverse order of removal.
1. DRAIN ENGINE COOLANT.
2. DISCONNECT UPPER RADIATOR HOSE FROM WATER OUTLET.
3. REMOVE NO.2 TIMING BELT COVER.
-
Disconnect the PS air hose from the clamp.
-
Disconnect the 3 cord clamps of the high-tension cords from the belt cover.
-
Remove the 6 bolts. timing belt cover and gasket.
-
Disconnect the camshaft position sensor connector.
4. REMOVE FUEL PIPE.
5. REMOVE ECT SENSOR.
-
Disconnect the ECT sensor connector.
-
Using a 19 mm deep socket wrench, remove the ECT sensor and gasket.
HINT: Use a new gasket upon reassembly.