|
Upholstery/Cushion - Rear Seat Backrest with
Loading Ease Flap, Remove and Install
 Remove
Rear seat backrest – see operation "Rear Seat Backrest,
Remove and Install". Centre armrest – see operation "Rear
Centre Armrest, Remove and Install", headrests.
|
Rear seat backrest hinge (2).
Release upholstery on back.
Only for left half: Disconnect loading ease flap (1) frame.
Release entire upholstery from rear seat backrest frame.
|
|
Headrest guide sleeve – see operation "Guide Sleeve
– Headrest, Remove and Install".
|
Unclip rear centre seat belt panel. Remove upholstery with
cushion.
Detach upholstery from cushion.
Lever off loading ease flap (1) frame bracket.
Note: Non-destructive
dismantling of the loading ease flap bracket and frame is not
required and they have to be replaced.
|
|
Caution
If rear seat upholstery is replaced, the following cuts must be
provided.
|
Right headrest (5), centre headrest (1), left headrest (3),
right rear seat backrest release (6), left right rear seat backrest
release (4), three-point seat belt, centre (2).
Install
Attach upholstery to cushion. Insert upholstery with cushion in
rear seat backrest frame. Fasten upholstery on rear seat backrest
around edge. Install new flap frame and bracket. Install new
headrest guide sleeves. Clip in centre seat belt panel. Attach
upholstery (rear side). Install rear seat backrest hinge, centre
armrest, rear seat backrest.
|
|
|
