|
Brake Hose, Rear, Left or Right, Remove and
Install
Top up brake fluid reservoir to "MAX" mark and seal with
MKM-558-10.
 Remove
|
Detach rear wheel. Detach brake line connection (1) from brake
hose (3) – collect escaping brake fluid and seal
apertures.
Unscrew banjo bolt (2) from brake calliper. Remove brake hose
(3) from bracket.
Install
Insert brake hose in bracket. Attach brake hose with banjo bolt
and new seal rings to brake calliper – tightening torque 40
Nm / 30 lbf. ft. – thereby ensuring brake hose is not twisted
once installed.
|
|
Insert brake line with tensioning plate and attach to brake hose
– tightening torque 16 Nm / 12 lbf. ft.
Attach rear wheel – 110 Nm / 81 lbf. ft.
Bleed brake system and check for leaks – see operation
"Brake System, Bleed and Check for Leaks".
Correct brake fluid level up to mark "MAX".
|
