|
Brake Anchor Plate – Rear Wheel Brake,
Remove and Install
 Remove
Top up brake fluid reservoir to "MAX" mark and seal with
MKM-558-10.
Detach rear wheel.
Remove brake drum – see operation "Brake Drum, Remove and
Install".
Remove rear wheel brake shoes – see operation "Brake Shoes
– Rear Wheel Brake, Remove and Install".
|
Remove wheel brake cylinder (1) – see operation "Wheel
Brake Cylinder, Remove and Install".
Detach retention clip (4) and remove parking brake cable (3)
from brake anchor plate.
Remove wheel bearing unit (2) with brake anchor plate for rear
axle – see operation "Wheel Bearing Unit, Remove and Install"
in group "F".
|
|
Install
Attach brake anchor plate with wheel bearing unit – see
operation "Wheel Bearing Unit, Remove and Install" in group
"F".
Insert parking brake cable in brake anchor plate and attach new
retention clip.
Install wheel brake cylinder – see operation "Wheel Brake
Cylinder, Remove and Install".
Install rear wheel brake shoes – see operation "Brake
Shoes – Rear Wheel Brake, Remove and Install".
Install brake drum – see operation "Brake Drum, Remove and
Install".
Attach rear wheel – 110 Nm / 81 lbf. ft.
Inspect
Bleed brake system and check for leaks – see operation
"Brake System, Bleed and Check for Leaks".
Actuate brake pedal repeatedly. Top up brake fluid to "MAX" mark
on brake fluid reservoir.
|
