Fan Motor, Remove and Install (with Air
Conditioning)
Remove
Remove battery and battery support – see operation
"Battery Support, Remove and Install" in group "A".
Remove front panelling – see operation "Front Panelling,
Remove and Install" in group "A".
Open coolant drain bolt – collect escaping coolant.
For X 16 SZR engine: Detach preheater hose (1) from heat shield
and resonator. Detach vacuum hose (2) from vacuum unit (intake air
preheating).
|
|
Detach or disconnect compressor wiring harness plug (6), air
conditioning pressure sensor (5), auxiliary fan (4), cooling module
control unit (2) and remove ground cable (3) from body –
expose wiring harness.
Remove lower coolant hose from radiator and put out of way
(rearwards).
Remove fastening bolts (1) from radiator and remove fan housing
with fan motor upward out of retainers.
|
|
Disconnect fan motor wiring harness plug (2).
Remove fastening bolt (3) and remove wiring harness plug with
series resistor – unclip cable bundle from fan housing.
Remove fastening bolts (1) and remove fan motor with fan wheel
from fan housing.
Remove fan wheel from fan motor.
Install
Attach fan wheel to fan motor. Attach fan motor to fan
housing.
Attach wiring harness plug with series resistor to fan housing
– clip wiring harness to fan housing.
Connect wiring harness plug for fan motor.
Insert fan housing with fan motor into bracket and attach to
radiator – tightening torque 5 Nm / 4 lbf. ft.
Install lower coolant hose on radiator.
|
|
Attach or connect wiring harness plug to compressor, air
conditioning pressure sensor, auxiliary fan and cooling module
control unit.
Attach ground cable to body.
Ensure correct cable routing.
For X 16 SZR engine: Connect vacuum hose to vacuum unit (intake
air preheating). Attach preheater hose to heat shield and
resonator.
Install front panelling – see operation "Front Panelling,
Remove and Install" in group "A".
Close coolant drain bolt.
Install battery support and battery – see operation
"Battery Support, Remove and Install" in group "A".
Inspect
Charge cooling system – see operations "Cooling System,
Charge and Bleed" and "Cooling System, Check for Leaks".
|