Insert housing with piston for multi-plate clutch C1 (1) in rear
cover.
Caution
When inserting in rear cover, ensure that the slotted seal rings
(x 4) do not get damaged.
Remove
Piston for multi-plate clutch C1 (2) – blow in low
pressure (arrow) compressed air. Replace piston seal rings (3 and
4) – coat with transmission fluid before installation.
Inspect
Lock ball of piston for multi-plate clutch C1 – shake
piston (5) to check whether lock ball is movable. Check return
springs assembly for damage, and replace if necessary. Check
sliding surfaces of steel and lining plates for damage and wear,
and replace if necessary. New lining plates must be laid in
transmission fluid for at least 2 hours before installation.
|