Bearing for Main and Drive Shaft in Transmission
Housing, Remove and Install (F17 New)".
Note: Transmission
remains installed.
Remove
1. |
Remove shift mechanism cover (1)
• |
see operation "Gearshift Cover, Remove and Install and/or Seal
(F13/F17/F17+/F18)"
|
|
2. |
Remove reversing lamp switch (2)
• |
Disconnect reversing lamp (3) switch wiring harness plug
|
• |
Unscrew reversing lamp switch
|
|
3. |
Remove end shield (4) cover
• |
See operation "Gasket for End Shield Cover, Replace
(F13/F17/F17+/F18)".
|
|
4. |
Remove end shield (5)
• |
See operation "Gasket for End Shield, Replace
(F13/F17/F17+/F18)".
|
|
5. |
Remove differential
• |
See operation "Differential Gear, Remove and Install
(F17/F17+)
|
|
|
|
6. |
Remove needle bearing 3) for drive shaft
• |
Pull needle bearing out of transmission housing using KM-556-A (1) and MKM-599 (2)
|
|
7. |
Remove roller bearing (4) for main shaft
• |
Pull roller bearing out of transmission housing using KM-556-A (6) and KM-556-2 (5)
|
|
|
|
Install
Important: Do not drive roller
bearing in until flush as this will damage the bearing.
|
8. |
Fit roller bearing (3) for main shaft
• |
Drive new roller bearing for main shaft bearing into
transmission housing with KM-454-3 (5) in
conjunction with KM-454-4 (4) as far as
the stop in the transmission housing
|
|
9. |
Fit needle bearing (2) for drive shaft
Note: Needle bearing
side with writing points to transmission.
• |
Drive new needle bearing flush in transmission housing using
KM-454-2 (6) and KM-454-4 (1)
|
|
|
|
10. |
Install differential
• |
See operation "Differential Gear, Remove and Install
(F17/F17+)
|
|
11. |
Install end shield (1)
Note: Note magnet.
• |
See operation "Gasket for End Shield, Replace
(F13/F17/F17+/F18)".
|
|
12. |
Fit end shield (2) cover
• |
See operation "Gasket for End Shield Cover, Replace
(F13/F17/F17+/F18)".
|
|
13. |
Fit gearshift cover (5)
• |
see operation "Gearshift Cover, Remove and Install and/or Seal
(F13/F17/F17+/F18)"
|
|
14. |
Transmission Fluid Level, Check and Correct
• |
see operation "Transmission Fluid, Check and Correct
(F13/F17/F17+/F18)"
|
|
15. |
Fit reversing lamp switch (3)
• |
Connect wiring harness plug (4)
|
• |
insert with new seal ring
|
• |
Tighten reversing lamp switch
– |
Tightening torque 20 Nm
|
|
|
|
|
|