Gasket for End Shield Cover, Replace
(F13/F13+/F17/F17+/F18)
Remove
If present: Remove lower engine compartment cover – see
operation "Lower Engine Compartment Cover, Remove and Install" in
group "A".
Remove end shield cover from transmission (9 fastening bolts,
arrows) – if necessary detach end shield cover with gentle
taps of rubber hammer.
Remove gasket.
|
|
Clean
Remove sealant residues and clean sealing surfaces.
Install
Attach end shield cover to
transmission with new gasket.
All transmissions except for F18
|
Tightening torque
|
M7 x 1.0
|
15 Nm / 11 lbf. ft.
|
|
|
M8 x 1.25
|
20 Nm / 15 lbf. ft.
|
Transmission F18
|
Tightening torque
|
M7 x 1.0
|
15 Nm / 11 lbf. ft.
|
New fastening bolts
|
|
M8 x 1.25
|
20 Nm / 15 lbf. ft. + 40°
|
|
|
|
|
Inspect
Check level of transmission fluid and correct if necessary
– see operation "Transmission Fluid Level, Check and Correct
(F13/F13+/F17/F17+/F18)".
Install
If present: Install lower engine compartment cover – see
operation "Lower Engine Compartment Cover, Remove and Install" in
group "A".
|