Vacuum Line – Brake Servo, Remove and
Install and / or Non-return Valve, Replace
Remove
1. |
Withdraw vacuum line with elbow (1) from brake servo
|
2. |
Detach snap fastening (2) for vacuum line from front intake
manifold (for vehicles with petrol engine) or from vacuum pump (for
vehicles with diesel engine)
• |
Detach snap fastening by pressing in the latch (arrow)
|
|
|
|
Install
4. |
Cut open vacuum line at connections (1) and (2) and remove from
connectors
|
5. |
Cut new vacuum line (rubber hose with textile inlay) to length
and fit with new clamps and KM-J-22610
Note: Ensure that the
arrow (3) on the non-return valve points in the direction of the
intake manifold or vacuum pump.
|
6. |
Press vacuum pressure lines with elbow into brake servo
|
7. |
Engage vacuum line snap fastening onto connector of intake
manifold or vacuum pump
Note: Ensure that all
the connections are perfectly sealed.
|
|
|
8. |
Check function of brake servo
|
|