Parking Brake Cable – Centre, Remove and
Install (Vehicle with Disc Brakes)
Remove
1. |
Remove cover of diagnostic connection
|
2. |
Unclip bellows (2) for parking brake lever out of central
console and draw up to hand grip (1)
|
3. |
Slacken parking brake cable at parking brake lever by turning
back the adjusting nut (3).
|
|
|
4. |
Lower exhaust system
• |
Secure exhaust system with strap
|
• |
Detach 2x rubber mounts
|
|
|
|
5. |
Detach heat shield
• |
Detach rubber mounts (2) for centre exhaust silencer
|
|
6. |
Twist handbrake cable front (3) 90° and remove
|
7. |
Remove handbrake cable from brackets (4)
|
|
|
8. |
Detach 2x handbrake cable from brake calliper
• |
Push down 2x brake calliper actuation lever (1) with
screwdriver and attach handbrake cable.
|
• |
Detach 2x retaining plate (2)
|
• |
Remove 2x handbrake cable
|
|
|
|
Install
9. |
Attach parking brake cable in retainers on rear axle, rear axle
bracket and to retainers (1) on fuel tank.
|
10. |
Hook front of parking brake cable (2) into parking brake cable
compensator and twist by 90° -
Note: Ensure that the
T-piece at the front end of the parking brake cable is seated
correctly in the parking brake cable compensator (arrow).
|
11. |
Push protective sleeve for front of parking brake cable (4) in
the direction of the parking brake cable compensator until it
passes over the bulge (3) on the parking brake cable
|
12. |
Attach parking brake cable to brake calliper
• |
Insert parking brake cable into retainer
|
• |
Attach new retaining clip to parking brake cable
|
• |
Push down actuating lever for brake calliper with a
screwdriver
|
• |
Hook parking brake cable into actuating lever for brake
calliper
|
|
13. |
Attach heat shield of central silencer (7) to vehicle underbody
2 Nm
|
14. |
Attach rubber mounts for central silencer (8) to vehicle
underbody
|
|
|
15. |
Attach exhaust system
• |
Attach 2x rubber mounts
|
|
16. |
Adjust parking brake lever path
|
|