Replace camshaft sensor
Remove
1. |
Remove air intake manifold
|
2. |
Remove engine vent hose from cylinder head cover
|
3. |
Detach air intake pipe from air intake hose
|
4. |
Detach air intake pipe from turbocharger
• |
Release clamp (3)
Note: Seal air intake
pipe at turbocharger
|
|
5. |
Remove air intake pipe
|
|
|
6. |
Remove air filter housing with mass air flow meter
• |
Detach mass air flow meter wiring harness plug (3)
|
• |
Detach air intake hose from air intake pipe
|
|
|
|
7. |
Remove fastening bolts (1) and remove top front toothed belt
cover from rear toothed belt cover
|
|
|
8. |
Detach cover (1) from cylinder head cover
|
9. |
Disconnect wiring harness plug from ignition module
|
10. |
Detach wiring harness plug (2) from camshaft sensor
|
11. |
Detach fastening bolt (3) from camshaft sensor
|
12. |
Remove camshaft sensor (4) from above
|
|
|
Install
13. |
Insert camshaft sensor from above and attach using fastening
bolt 6 Nm
|
14. |
Attach top front toothed belt cover to rear toothed belt cover
6Nm
|
15. |
Connect wiring harness plug to camshaft sensor
|
16. |
Attach cover to cylinder head cover
|
17. |
Attach wiring harness plug to ignition module
|
18. |
Remove seal from turbocharger air intake pipe
|
19. |
Attach engine vent hose to cylinder head cover
|
20. |
Attach air intake pipe to turbocharger
|
21. |
Attach air intake pipe to air intake hose
|
|