Replace drive shaft and/or ball bearing (F13/F13
MTA)
Note: Transmission
remains installed.
Overview of Drive Shaft
Remove
|
1. |
Remove gearbox cover (1)
Note: For F13
transmission.
Remove gearshift module (2)
Note: For F13 MTA
transmission.
|
2. |
Remove reversing lamps switch (3).
• |
Disconnect wiring harness plug, reversing lamp switch
|
• |
Unscrew reversing lamp switch
|
|
|
3. |
Remove front axle body
|
Important: Do not damage wiring
harnesses and attaching parts
|
4. |
Lower engine and transmission on the left hand side
|
|
5. |
Remove end shield (1) cover
|
|
|
7. |
Attach KM-6001-B to front axle
body
Note: The guide pins
must sit in the support bearing with no play.
• |
Release 2x bolt (arrows) for adjustment rails on KM-6001-B (1)
|
• |
Insert KM-6001-B as shown
Note: 2x journals (2)
and (5) must sit flush in the guide holes of the front axle
body.
|
• |
Tighten 2x bolt for adjustment rails
|
• |
Twist up front support bearing (4)
– |
until the guide pin is in contact with the front of the engine
damping block
|
|
• |
Twist up rear support bearing (3)
– |
until the guide pin is in contact with the rear of the engine
damping block
|
|
|
|
8. |
Remove drive shaft
Note: If gear cluster
teeth are damaged, always check the corresponding gear on the main
shaft and replace if necessary.
|
|
Important: Note installation
position.
|
9. |
Detach ball bearing (2) from drive shaft (3)
• |
Press ball bearing (2) off drive shaft with KM-407-A (1)
|
|
|
Install
|
10. |
Attach ball bearing (3) to drive shaft (2)
• |
Press ball bearing on to drive shaft with KM-311-2 (4)
|
• |
Attach new retaining ring (1) to drive shaft
|
|
|
|
12. |
Install end shield (2)
|
13. |
Attach end shield cover (1)
|
|
Important: Do not damage wiring
harnesses and attaching parts
|
14. |
Raise engine and transmission on the left hand side
|
15. |
Install front axle body
|
16. |
Detach KM-6001-B from front axle
body
|
|
17. |
Install gearbox cover (1)
Note: For F13
transmission.
Install gearshift module (2)
Note: For F13 MTA
transmission.
|
18. |
Fit reversing lamp switch (3)
• |
Tighten reversing lamp switch
|
• |
Connect wiring harness plug for reversing lamp switch
|
|
|
19. |
Correct transmission fluid level
|
|