Replace transmission housing (F13/F13 MTA)
Overview of Transmission Housing
Remove
|
2. |
Attach transmission to KM-6115
(2)
|
3. |
Attach transmission to KM-113-2 (1)
using KM-6115
|
|
4. |
Remove left engine damping block bracket
|
5. |
Put transmission into neutral
|
6. |
Remove gearbox cover (2)
Note: For F13 only.
|
7. |
Remove gearshift module
Note: For F13 MTA
only.
|
8. |
Unscrew reversing lamps switch (1)
Note: For F13 only.
|
9. |
Remove end shield cover (4)
|
10. |
Remove end shield (3)
|
|
|
|
13. |
Remove central release (5)
|
14. |
Remove pressure line (4) and pressure line fixing sleeve (3)
|
15. |
Remove bearing for main (2) and drive shaft (1) from
transmission housing
|
|
16. |
Remove 2x axle shaft seal ring
|
17. |
Remove transmission housing form KM-6115
|
Install
18. |
Attach new transmission housing to KM-6115
|
|
19. |
Install bearings for main (2) and drive shaft (1)
|
21. |
Install pressure line (4) and fixing sleeve pressure line (3)
|
22. |
Install central release (5)
|
|
23. |
Attach KM-6155 to transmission.
|
24. |
Install end shield (3)
Note: Note magnet.
|
25. |
Attach end shield cover (4)
|
26. |
Install gearbox cover (2)
Note: For F13 only.
|
27. |
Install gearshift module
Note: For F13 MTA
only.
|
28. |
Fit reversing lamp switch (1)
Note: For F13 only.
• |
Tighten reversing lamp switch 20
Nm
Note: Use new seal
ring.
|
|
|
|
29. |
Install 2x axle shaft seal ring
|
30. |
Install left engine damping block
|
|
31. |
Detach transmission from KM-113-2 (1)
using KM-6115 (2)
|
32. |
Detach transmission from KM-6115
|
|
|