vauxhall Workshop Repair Guides

Vauxhall Workshop Service and Repair Manuals

ABOUT US
Combined Tail Light / Lamp Holder (Circuit Board), Replace L08 > < Fully replace combined tail light L48

Astra H

Combined Tail Light / Lamp Holder (Circuit Board), Replace L35/L70

  Remove

1.   Open service flap.
2.   Remove rear lamp
•   Unscrew 3x wing nut (1)
•   Remove tail light
– Disconnect wiring harness plug (3
3.   Remove lamp holder
•   Remove gasket
•   Unscrew 3x bolt (2)
– Remove bulb holder
•   Remove bulb
Object Number: 7361026 Size: DEFAULT


  Install

4.   Install bulb holder
•   Insert bulb
•   Insert holder
•   Tighten 3x bolt
Important:   Before fitting the tail light, check that the tail light gasket (1) is seated correctly.
5.   Attach gasket
Object Number: 10678875 Size: DEFAULT


6.   Install tail light
•   Insert tail light
– Connect wiring harness plug
•   Tighten 3x wing nut
7.   Close service flap

Combined Tail Light / Lamp Holder (Circuit Board), Replace L08 > < Fully replace combined tail light L48