Rocker Panel Decal Replacement
Callout
|
Component Name
|
1
|
Rocker Panel Decal
Caution: Refer to
Exterior Trim Emblem Removal
Caution .
Procedure
|
1. |
The part and surface should be 21°C (70°F)
prior to installation. The vehicle should remain 21°C
(70°F) for one hour after assembly to allow adhesive to develop
sufficient bond strength. |
|
2. |
Use a Heat Gun or equivalent to remove the old
decal. Clean all adhesive from the rocker panel and wipe the
surface dry with a clean lint free towel prior to installing the
new decal. |
|
3. |
When removing protective liners from the adhesive
tape, be careful not to touch tape with hands and do not allow the
tape to come in contact with dirt or any foreign matter prior to
adhesion. |
|
4. |
Using the palm of the hand, wet out the decal to
the rocker panel to ensure full adhesion of the emblem is
made. |
|
|
|
|