Window Regulator Motor Programming and Setup
Window Motor Normalized Procedure
A window motor that has not been normalized will no longer
perform the express up and express down functions, this may occur
during the following conditions:
• |
When a window motor has been
disconnected or replaced |
• |
When a door harness has been
disconnected |
• |
When the battery has been
disconnected or replaced |
Note: When DTC
B3205 4B & 3210 4B are set, the following warnings
will be displayed on the driver information center:
Open, then Close Driver Window
Open, then Close Passenger Window
These warnings will clear once the windows have been
"Normalized" and the respective DTC will clear.
To normalize the window motor, follow these steps:
|
Note: The doors must
be completely closed prior to normalizing the windows, a door that
is open or ajar may cause the power window to function abnormally
or to become inoperative while performing the normalizing
procedure. If this occurs, verify that the door is completely
closed then repeat the normalizing procedure.
|
|
Note: For vehicles
equipped with a folding convertible top, the top must be closed and
firmly latched prior to normalizing the windows.
|
2. |
Starting with the window
completely UP, press and hold the power window switch until the
window is fully open and continue holding the switch down for
approximately 5 seconds after the window is completely open.
|
3. |
Pull the power window switch
up until the window is fully closed and continue holding the switch
up for approximately 5 seconds after the window is completely
closed. |
The window should now be normalized and the window should
perform the express up and express down functions.
Window Motor Relearn Procedure
A relearn procedure may need to be performed for any Local
Interconnect Network (LIN) window motor for the following
conditions:
• |
When the window glass is out
of alignment |
• |
When the window glass has been
replaced |
• |
When the door has been
replaced |
• |
When the window regulator has
been replaced |
Note: Prior to performing
the relearn procedure the vehicle must have all 4 wheels properly
inflated and mounted, the vehicle must be sitting on a level
surface and all doors must be completely closed and for vehicles
equipped with a folding convertible top, the top must be closed and
firmly latched..
To relearn the window motor, follow these steps:
2. |
With a scan tool, select
Module Diagnosis, Body Control Module, Configuration/Reset
Functions and then select the appropriate Clear Window Learn Values
for the window motor requiring the relearn procedure. |
3. |
After the learn procedure,
exit the scan tool learn procedure completely, the power window
cannot be normalized and will not function until you exit the
program. |
4. |
Starting with the window
completely UP, press and hold the power window switch until the
window is fully open and continue holding the switch down for
approximately 5 seconds after the window is completely open.
|
5. |
Pull the power window switch
up until the window is fully closed and continue holding the switch
up for approximately 5 seconds after the window is completely
closed. |
The window is now reprogrammed.
|