Chime Malfunction
Diagnostic Instructions
Circuit/System Description
The radio or the chime module, if not equipped with a radio,
generates the audible warnings. The instrument cluster, the body
control module (BCM), the inflatable restraint sensing and
diagnostic module (SDM) or the object alarm module request audible
warnings via Low Speed CAN-Bus signals.
Reference Information
Schematic Reference
Audible Warnings Schematics
Connector End View Reference
Component Connector End Views
Description and Operation
Audible Warnings Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
Note: Before performing
this diagnostics, make sure no indicators are illuminated after the
instrument cluster performs a lamp test. If any indicators are
illuminated after the bulb test, perform the indicator diagnostics
before this diagnostics.
Without Radio
Ignition ON, perform the Chime test with the scan tool, verify that
all audible warnings sound normal.
If the audible warnings do not operate properly, replace the P5
Chime Alarm Control Module.
With Radio
1. |
Ignition ON, radio ON, adjust
the radio balance and fade to each speaker. |
2. |
Ignition ON, buckle up driver
seat belt, verify the scan tool Driver Seat Belt Status parameter
is Buckled. |
3. |
Ignition ON, headlamp switch
OFF, verify the scan tool Headlamp On Switch parameter is
Inactive. |
4. |
Ignition ON, parking lamp
switch OFF, verify the scan tool Park Lamps Switch parameter is
Inactive. |
5. |
Ignition ON, turn signal
switch OFF, verify the scan tool Left Turn Signal Switch parameter
and the scan tool Right Turn Signal Switch parameter is
Inactive. |
6. |
Ignition ON, parking brake
released, verify the scan tool Park Brake Switch parameter is
Inactive. |
7. |
Ignition ON, doors closed,
verify that all scan tool parameters listed below are
Inactive. |
|
• |
Driver Door Ajar Switch
|
|
• |
Passenger Door Ajar
Switch |
|
• |
Left Rear Door Ajar
Switch |
|
• |
Right Rear Door Ajar
Switch |
8. |
Verify the scan tool Key in
Ignition Status parameter is Inactive when the key is in the
ignition and Active when the key is out of the ignition.
|
⇒ |
If the scan tool parameter does not operate
properly, replace the K9 Body Control Module. |
9. |
Ignition ON, verify the scan
tool Park Assist Switch parameter is Active when the parking assist
is active and Inactive when the parking assist is Inactive.
|
10. |
If all tests operate properly,
replace the A11 Radio. |
Repair Instructions
Perform the
Diagnostic Repair Verification after completing the diagnostic
procedure.
Control Module References for BCM, or Radio replacement, setup,
and programming
|