vauxhall Workshop Repair Guides

Vauxhall Workshop Service and Repair Manuals

Crankshaft Position Sensor Replacement - 1.7L Diesel LPL and LPV > < Fuel Tank Filler Pipe Replacement

Glow Plug Replacement (1.7L Diesel LPL and LPV)

Special Tools

EN-48558   Glow Plug Socket Remover

For equivalent regional tools, refer to Special Tools .

Removal Procedure

1. Open the hood.
2. Remove the engine sight shield. Refer to Engine Sight Shield Replacement .
3. Clean around of each glow plug.

           2191930



Caution: Use care when disconnecting the glow plug electrical connector. Use of excessive force may damage the electrical connector.

4. Disconnect the 4 glow plug wiring harness plugs (1), using the EN-48558   socket remover .

           2191933




Note:  The graphic shows the engine without the fuel injection components to simplify the illustration.
5. Remove the 4 glow plugs (1).

Installation Procedure


Caution: Refer to Fastener Caution .


           2191933




Note:  The graphic shows the engine without the fuel injection components to simplify the illustration.
1. Install the 4 glow plugs (1) and tighten to 14 N·m (124 lb in) .

           2191930



2. Connect the 4 glow plug wiring harness plugs (1).
3. Install the engine sight shield. Refer to Engine Sight Shield Replacement .
4. Close the hood.

Crankshaft Position Sensor Replacement - 1.7L Diesel LPL and LPV > < Fuel Tank Filler Pipe Replacement