DTC U0400-U05FF
Diagnostic Instructions
DTC Descriptor
Refer to
Control Module U Code List .
Circuit/System Description
Some control modules are constantly receiving information from
other control modules through serial data communication network.
The invalid data code will be set when a receiving control module
detects a discrepancy in information it receives from another
control module causing its integrity to be questioned. The symptom
byte listed in the DTC Descriptor is for engineering reference
only. No external circuit diagnosis is involved.
Conditions for Running the DTC
Battery voltage is between 9-16 V and data link communications
operate normally.
Conditions for Setting the DTC
The control module is not configured properly.
Conditions for Clearing the DTC
| • |
A current DTC clears when the
malfunction is no longer present. |
| • |
A history DTC clears when the
module ignition cycle counter reaches the reset threshold, without
a repeat of the malfunction. |
Reference Information
Schematic Reference
Data Communication Schematics
Connector End View Reference
Component Connector End Views
Description and Operation
Data Link Communications Description and Operation
Electrical Information Reference
Scan Tool References
Control Module References for scan tool information
Circuit/System Verification
| 1. |
Engine running for 10
seconds. |
| 2. |
Ignition ON, engine OFF,
verify the DTC U0400-U05FF is not set. |
| ⇒ |
If the DTC U0400-U05FF is set without other DTCs
set, program the control module specified by the DTC descriptor. If
the DTC resets, replace the appropriate control module. |
Repair Instructions
Perform the
Diagnostic Repair Verification after completing the diagnostic
procedure.
Control Module References for control module replacement,
setup, and programming
|
