Kostal Connectors (Transmission)
Special Tools
• |
EL-38125-580
Terminal Release Tool Kit |
• |
J-38125-28
Terminal Release Tool |
For equivalent regional tools, refer to
Special Tools .
Terminal Removal Procedure
1. |
While depressing the lock,
twist and remove the connector from the component. |
2. |
Locate the terminal position
assurance (TPA). |
|
Note: The TPA cannot
be removed from the connector while there are terminals present in
the connector body.
|
3. |
Use a small flat-blade tool to
push the TPA until it bottoms out. |
4. |
Use the J-38125-28 tool to
release the terminals by inserting the tool into the terminal
cavity as shown in the graphic. |
5. |
While holding the removal tool
in place, gently pull the wire out of the back of the connector.
Always remember never use force when pulling a terminal out of a
connector. |
Terminal Insertion Procedure
After the terminal is replaced, perform the following procedure
in order to insert the terminal.
1. |
Slide the new terminal into
the correct cavity at the back of the connector. |
2. |
Push the terminal into the
connector until it locks into place. The new terminal should be
even with the other terminals. Ensure that the terminal is locked
in place by gently pulling on the wire. |
4. |
Use a small flat-blade tool to
push the TPA until it bottoms out. |
5. |
Ensure the TPA is fully
seated. The TPA should be centered and flush with the connector
body when viewed. |
|