Using Connector Test Adapters
Special Tools
| • |
EL-35616
Terminal Test Probe Kit |
| • |
EL-38125-550
Terminal Release Tool Kit |
For equivalent regional tools, refer to
Special Tools .
|
Caution: Do
not insert test equipment probes (DMM etc.) into any connector or
fuse block terminal. The diameter of the test probes will deform
most terminals. A deformed terminal will cause a poor connection,
which will result in a system failure. Always use the EL-38125-580
GM Approved Terminal Release Tool Kit in order to front probe
terminals. Do not use paper clips or other substitutes to probe
terminals. When using the EL-38125-580
GM Approved Terminal Release Tool Kit , ensure the terminal test
adapter choice is the correct size for the connector terminal. Do
not visually choose the terminal test adapter because some
connector terminal cavities may appear larger than the actual
terminal in the cavity. Using a larger terminal test adapter will
damage the terminal. Refer to the EL-38125-580 GM Approved Terminal
Release Tool Kit label on the inside of the EL-38125-580 GM
Approved Terminal Release Tool Kit for the correct adapter along
with the connector end view for terminal size. |
|
