Bosch Connectors (2.8 JPT)
Special Tools
• |
EL-38125-580
Terminal Release Tool Kit |
• |
J-38125-557
Terminal Release Tool |
For equivalent regional tools, refer to
Special Tools .
Terminal Removal Procedure
1. |
Pull out the slider on the
connector position assurance (CPA) until it is at the end of its
travel. |
2. |
Disconnect the connector from
the component. |
3. |
Remove the wire dress cover,
if necessary. |
4. |
Push the wire side of the
terminal that is being removed toward the connector and hold it in
position. |
5. |
Insert the J-38125-557 into
the 2 cavities on each side of the terminal at the front of
the connector and push until you feel the tool disengage the
terminal retainers. |
6. |
Carefully pull the terminal
out of the connector. Always remember never use force when pulling
a terminal out of a connector. If the terminal is difficult to
remove, repeat the entire procedure. |
8. |
Insert the repaired terminal
back into the cavity. Repeat the diagnostic procedure to verify the
repair and reconnect the connector bodies. |
|