Kostal Connectors (Glow Plug Control Module)
Special Tools
| • |
EL-38125-580
Terminal Release Tool Kit |
| • |
J-38125-24
Terminal Release Tool |
| • |
J-38125-560
Terminal Release Tool |
For equivalent regional tools, refer to
Special Tools .
Terminal Removal Procedure
View of typical connector.
View of connector in released position.
| 1. |
Locate the assist lever at the
back of the connector. Move the assist lever to the rear
position. |
| 2. |
Disconnect the connector from
the component. |
| 3. |
Use a small flat-blade tool to
remove the dress cover. |
| 4. |
Slide the dress cover forward
and off of the connector. |
| 5. |
The terminal positive
assurance (TPA) is located in the front and rear of the
connector. |
|
Note: The front TPA
cannot be removed from the connector. Only move it to the preset
position.
|
| 6. |
Use a small flat-blade tool to
move the front TPA to the preset position, outboard approximately
0.125 in. (3 mm). |
| 7. |
Use a small flat-blade tool to
completely remove the rear TPA from the connector. |
| 8. |
Use the J-38125-24 or the
J-38125-560 tool to release the terminals by inserting the tool
into the terminal release cavity. |
| 9. |
While holding the removal tool
in place, gently pull the wire out of the back of the connector.
Always remember never use force when pulling a terminal out of a
connector. |
|
